Introduction of Shuttering Magnets

Usage

When the Precast concrete magnet is in use, the bottom of the magnet is firmly attached to the steel mold platform.        (The magnet and the platform form a complete magnetic circuit closing system.)        This circuit exhibits an ultra-strong holding force.        The shuttering magnet will not budge, slip, or shift while in use, making it much safer and user-friendly.

Lifting the magnet to the platform

When the precast concrete magnet is not in use, there’s a gap between the magnet and the platform. The magnetic circuit is not saturated, and the holding force is reduced.This is the time to pry the shuttering magnets open with a tool and begin using it with the platform.

Instructions for safe use

To ensure your shuttering magnets can last through countless uses, be sure to treat them with care. Below are some tips on how you can help lengthen the lifespan of your shuttering magnet.

Don’t exceed heat over 80 degrees celsius.(The magnet will not function properly when too hot)

Don’t roughhouse with it.  Don’t randomly toss it or throw it on a table.

Regular magnet cleaning is essential to keep rust and corrosion at a minimum

Don’t put any foreign matter on the surface of the adsorption die

Precautions

Much like anything else, there are some precautions to take when using our magnets.These are not only for your safety but to ensure the precast concrete magnet performs as it should.

Clean shuttering magnets

1.The internal components of the neodymium magnet must be kept clean.Avoid debris entering the template magnet.If foreign material makes its way in, the magnetic force will be in jeopardy.

2.The maximum operating or storage temperature must be below 80 ° C. Higher temperatures may cause the template magnet to decrease or lose its magnetic force completely.The temperature of a standard curing furnace is below 60 ℃ so the magnet can enter directly. If the curing furnace’s temperature is higher than 80 ℃, remove the magnet before entering the curing furnace.

3. Keep the shuttering magnet away from electronic devices and unnecessary ferromagnetic metals.This includes mobile phones, tablets, smartwatches, laptops, and computers.Almost no magnetic force is felt outside the steel casing of the shuttering magnets, but the magnetic force inside is extremely strong.

3.Keep the shuttering magnet away from electronic devices and unnecessary ferromagnetic metals. This includes mobile phones, tablets, smartwatches, laptops, and computers.Almost no magnetic force is felt outside the steel casing of the shuttering magnets, but the magnetic force inside is extremely strong.

Safety note* If someone wears a pacemaker, extra care should be taken because strong magnetic fields can damage electronic devices inside the pacemaker.